CLASS RULES

Spring & Summer 2018 Outdoor Parking Lot Rules

For the 2018 Season we will be applying WCICS, Roar & TCS Rules for the following classes.


Mini

* See Mini on-road carpet rules


Euro Truck

1. Box kit build

2. 6 cell nimh  or 2 cell lipo

3. Ball bearings allowed

4. No chassis modifications

5. Stock ESC & Motor


2WD 1/10 Off-Road 

* See ROAR rules

1. Open ESC & Motor

2. 2 cell lipo or equivalent nimh


4WD 1/10 Off-Road 

* See ROAR Rules

1. Open ESC & Motor

2. 2 cell lipo or equivalent nimh


On-Road Carpet Rules
For the 2017/2018 Season we will be applying WCICS, Roar & TCS Rules for the following classes
 

Mini
1. Chassis - Any Tamiya M Chassis car - Assembled as per instruction manual. (I E : No FWD to RWD M-03 conversions) Unnecessary parts may be left off during assembly (IE: rolls bars on M-05, electronics trays) but no part may be sawed, cut, or milled from chassis.
2. Drivetrain - Open Diff and Drivetrain, maintaining the kit FDR. 16, 18 and 20 tooth pinions in M-03/M-05/M-06. 17 and 19 tooth pinion only in M-04. 21 tooth pinion not permitted.
3. Hop Ups - All other Tamiya or aftermarket hop ups are permitted.
4. Motor/ESC - Spec Orca Q combo only, set to zero timing/boost (blinky mode must be active) or sealed Johnson/Mabuchi 27t silver can kit type motor. Open brushed ESC. No modifications to motors or ESCs permitted. Silver cans will not be permitted to advance beyond the C main. Tamiya Silver can 540J motor (Item 53689) is permitted for club racing.
NOTE: Johnson 540-J motors are limited to 18,750 RPM / Tested after race or main of 10min or sooner / 7.2v for 22 sec
5. Wheels/Tires - Tamiya branded mini sized tires and inserts only. Double stuffing not permitted. Any mini sized wheel.
6. Bodies - Open to any mini sized body with the following restrictions - No touring sedan and/or 12th scale type wedge/Can Am bodies. Bodies must be cut and painted along the factory body lines.
7. Battery - Any 2S, 7.4V, round edged, hard cased lipo pack that will fit the mini (IE: M-03) chassis (without modification to pack or chassis). Capacity limit of 5000mAh.
8. Minimum Weight - 1200g
9. Any modification not called out specifically in these rules is not legal. Infractions called out during tech are binding.
10. 5 min race.
11. No ride height restrictions
 

F-1
1. 21.5t ROAR or BRCA approved Stock Spec
2. No ESC timing or boost. ESC must be on ROAR or BRCA approved list
3. 190mm Maximum
4. F1 scale. Molded front/rear wings. No lexan wings
5. Any pinion and spur gear ratio combo may be used.
6. 2-wheel rear drive cars only; 270mm Maximum wheel base; All suspensions allowed, including IFS suspensions. All front suspension mounting points must be located entirely within the body shell (no pan-car front suspension systems). Adjustable link front ends are OK as long as the inner mount point is located within the body.
7. 2S Li-Poly battery packs must have a hard, protective case as per ROAR 8.3.2.2
8. 5 minute race.
9. 4mm ride height min.
10. 1050g min weight

CTA
1. 1450g min. weight.
2. Four Wheel Drive touring car chassis only. Any era or brand 4wd chassis is allowed.
3. HPI tire part #4793 "front" and #4797 "rear" using single stock tire inserts provided with tire and any HPI Vintage wheels designed to fit these tires. All other tires are illegal.HPI wheel part #3805 through #3822, #3854 through #3860, #33472 and #33473, #33474 and #33475 are the only legal options. Wheels/tires designated as "front" or "rear" must be used as intended. Grinding of tire tread is NOT permitted. Sanding of mold seam to remove seam is allowed.
4. 2S Li-Poly battery packs must have a hard, protective case as per ROAR 8.3.2.2
5. 21.5 Brushless Motor.
6. NON Boosted ESC; ESC must be on ROAR approved list.
7. Late '60s to early '70s American pony car Vintage Trans-Am bodies only. Body provided deck lid spoilers allowed (not wings). No additional skirts or raised/extended wings or air control surfaces allowed. Body must be trimmed at body trim lines. Full rear bumper required. It is highly preferred that bodies are detailed in race type livery in period-correct paint schemes. Driver and/or lights preferred, but not required.
8. 5 minute race.
9. 5mm ride height min.

USGT
1. 4WD: 1450g min weight / FWD: 1250g min. weight.
2. Any on-road FWD or 4WD 1/10th scale TC Chassis
3. Gravity USGT/Ride 24025 with included inserts. Any 24 or 26mm spoked (non-dish) type wheel
4. 2S Li-Poly battery packs must have a hard, protective case as per ROAR 8.3.2.2
5. 21.5t Brushless motor ROAR or BRCA Approved. Open gearing.
6. NON Boosted ESC; ESC must be on ROAR approved list.
7. Any 190mm or 200mm body. Body can be any body that is NOT on the ROAR T2 or WGT body list. No bodies intended for pan cars or USVTA are allowed.
8. 5 minute race.
9. 5mm ride height min.
 

WGT-R
1. 5 minutes
2. CRC mounted RT1 rubber tires on CRC GTR wheels. (# 2314 / 2311 / 2313 / 2310)
3. 1S Li-Poly battery packs must have a hard, protective case as per ROAR 8.3.2.2
4. 13.5 Brushless Motor
5. NO ESC timing and boost allowed
6. Max. body width 200mm.
7. 1025g min. weight.
8. 5mm ride height min.

2WD INDOOR OFF-ROAD
1. 5 minutes
2. ProLine "Prime" 2.2" Buggy & Stadium Truck appropriate tires with 2.2" dish style wheels
3. 2S Li-Poly battery packs must have a hard, protective case as per ROAR 8.3.2.2
4. Open brushless motor
5. Boosted ESC allowed
6. 5mm ride height min.
7. No weight restriction
8. Chassis protectors are MANDITORY!

 

RACE WITH US!